Description
ETAL P5100 P5100 is intended for low-cost, medium-speed data and voice applications. is a direct substitute for industry standard P1200, being mechanically compatible and having identical signal/distortion and matching characteristics, and suitable for supplementary insulation, 250V working. P5100 uses patented design and construction methods to achieve excellent signal performance and safety isolation to international standards. P5100 is certified to IEC 60950 and a UL Recognized Component and is supported by an IEC CB certificate. The part is completely lead-free, compliant with RoHS Directive 2002/95/EC, and suitable for lead-free and conventional processing.
Lead-free (Pb-free) RoHS compliant 11mm (0.43″) seated height Industry Standard Pinout IEC 60950 and UL 60950 Certified High thermal stability
DESCRIPTION
P5100 is intended for low-cost, medium-speed data and voice applications. is a direct substitute for industry standard P1200, being mechanically compatible and having identical signal/distortion and matching characteristics, and suitable for supplementary insulation, 250V working. P5100 uses patented design and construction methods to achieve excellent signal performance and safety isolation to international standards. P5100 is certified to IEC 60950 and a UL Recognized Component and is supported by an IEC CB certificate. The part is completely lead-free, compliant with RoHS Directive 2002/95/EC, and suitable for lead-free and conventional processing.
SPECIFICATIONS
Electrical = 25ºC and as circuit fig. 2 unless otherwise stated. Parameter Insertion Loss Frequency response Return Loss Third Harmonic Distortion (1) Voltage isolation (2) Operating range: Functional Storage Conditions 450Hz 0dBm Min 18 Typ -72 Max ±0.2 -60 Units dB dBm
Lumped equivalent circuit parameters as Fig. 1 DC resistance, RDC (3) Leakage inductance L Shunt inductance Lp (4) Shunt loss Rp (4) Notes 10mV 200Hz Sum of windings H k
1. Third harmonic typically exceeds other harmonics 20dB. 2. Components are 100% tested at 3.25kV DC. 3. Caution: do not pass DC through windings. Telephone line current, etc. must be diverted using choke or semiconductor line hold circuit. 4. At signal levels greater than 100mV, Lp will increase and Rp will decrease slightly but the effect is usually favourable to the return loss characteristic.
Figure 3 gives flat RX and TX responses against the CTR21 complex reference impedance (typically around – 3.4kHz). Return loss is typically better than 20dB. The circuit values in parentheses give optimum flatness at a small sacrifice in return loss. For circuits with existing board drillings, figure 4 gives good return loss (>20dB) and RX flatness against the CTR21 complex reference impedance, but TX flatness is degraded by the use of this topology.
Dimensions shown are in millimetres (inches). Geometric centres of outline and pin grid coincide within a tolerance circle of 0.6mm Windings may be used interchangeably as primary or secondary.
- TRANSFORMER, LINE MATCHING, V.32 BIS
- Primary Voltages: –
- Secondary Voltages: –
- Current Rating: 100µA
- Plug Type: –
- SVHC: No SVHC (16-Dec-2013)
- Approval Bodies: BABT, CSA, EN, UL
- External Depth: 18mm
- External Length / Height: 12.6mm
- External Width: 18mm
- Mounting Type: PCB
- Pin Diameter: 0.65mm
- Transformer Type: Matching
Manufacturer Part Number: P5100
Manufacturer: Etal
