Description
LM75BIMM-3/NOPB Texas Instruments Temp Sensor Digital Serial (2-Wire, I2C) 8-Pin VSSOP RoHS
Specifications
Manufacturer: Texas Instruments
Product Category: Board Mount Temperature Sensors
RoHS
Output Type: Digital
Configuration: Local
Accuracy: +/- 3 C
Supply Voltage – Min: 3 V
Supply Voltage – Max: 5.5 V
Interface Type: 2-Wire, I2C, SMBus
Resolution: 9 bit
Minimum Operating Temperature: – 55 C
Maximum Operating Temperature: + 125 C
Shutdown: Shutdown
Temperature Threshold: Programmable
Mounting Style: SMD/SMT
Package / Case: VSSOP-8
Product: Sensor with Overtemp
Packaging: Cut Tape
Packaging: Reel
Output Current: 10 uA
Series: LM75B
Brand: Texas Instruments
Operating Supply Current: 280 uA
Product Type: Temperature Sensors
Factory Pack Quantity: 1000
Subcategory: Sensors
Unit Weight: 0.001101 oz
The LM75B is a temperature-to-digital converter using an on-chip band gap temperature sensor and Sigma-Delta A-to-D conversion technique with an overtemperature detection output. The LM75B contains a number of data registers: Configuration register (Conf) to store the device settings such as device operation mode, OS operation mode, OS polarity and OS fault queue; temperature register (Temp) to store the digital temp reading, and set-point registers (Tos and Thyst) to store programmable overtemperature shutdown and hysteresis limits, that can be communicated by a controller via the 2-wire serial I²C-bus interface. The device also includes an open-drain output (OS) which becomes active when the temperature exceeds the programmed limits. There are three selectable logic address pins so that eight devices can be connected on the same bus without address conflict. The LM75B can be configured for different operation conditions. It can be set in normal mode to periodically monitor the ambient temperature, or in shutdown mode to minimize power consumption. The OS output operates in either of two selectable modes: OS comparator mode or OS interrupt mode. Its active state can be selected as either HIGH or LOW. The fault queue that defines the number of consecutive faults in order to activate the OS output is programmable as well as the set-point limits. The temperature register always stores an 11-bit two’s complement data giving a temperature resolution of 0.125 °C. This high temperature resolution is particularly useful in applications of measuring precisely the thermal drift or runaway. When the LM75B is accessed the conversion in process is not interrupted (that is, the I²C-bus section is totally independent of the Sigma-Delta converter section) and accessing the LM75B continuously without waiting at least one conversion time between communications will not prevent the device from updating the Temp register with a new conversion result. The new conversion result will be available immediately after the Temp register is updated. The LM75B powers up in the normal operation mode with the OS in comparator mode, temperature threshold of 80 °C and hysteresis of 75 °C, so that it can be used as a stand-alone thermostat with those pre-defined temperature set points.
Manufacturer Part Number: LM75BIMM-3/NOPB
Manufacturer: Texas Instruments
